2chance1
Registered user
Registered: 08-2012
Posts: 2
|
Reply | Quote
|
|
Gap Jump Issues
I have seen tracks that have working gap jumps/crossovers, but I must not be doing things right. Because on my Los Angeles and Texas RallyCross tracks, I always get a result like this:
http://www.youtube.com/watch?v=7YPXkIra4tE
I have come to the conclusion that the jump is messed up, the crossover would work find if I figured out why I keep hitting invisible walls when jumping.
|
8/2/2012, 12:35 am
|
Link to this post
PM 2chance1
Blog
|
amtronic
Administrator
Registered: 01-2012
Posts: 586
|
Reply | Quote
|
|
Re: Gap Jump Issues
Is EVERY track segment anywhere near the problem area set to Open on Left and Open on Right?
And I can't tell what your height settings are, you may have a spot between segment tie points that is causing the problem.
And is every single X point set for Mode Absolute? If not, your car can hit the end of an X section like a brick wall.
--- http://nr2k3tracks.com/
for tracks, mods, and utilities.
|
8/2/2012, 9:12 am
|
Link to this post
PM amtronic
Blog
|
2chance1
Registered user
Registered: 08-2012
Posts: 2
|
Reply | Quote
|
|
Re: Gap Jump Issues
Everything is open on left and right. So I'm thinking its the mode absolute.
|
8/2/2012, 3:16 pm
|
Link to this post
PM 2chance1
Blog
|
Smiffsden
Registered user
Registered: 01-2012
Posts: 204
|
Reply | Quote
|
|
Re: Gap Jump Issues
You're getting what they call elsewhere a divide by 0 error, the physics engine is having a spat because the down section of the launch ramp is too sharp.
Try making the ramps slightly longer and more inclined up so that the car is launched off the ground itself before the end of the ramp, then don't make the down section so sharp and it won't happen.
Last edited by Smiffsden, 8/22/2012, 7:50 am
|
8/22/2012, 7:49 am
|
Link to this post
PM Smiffsden
Blog
|